

Low Water Pressure at Home? What Could Be Causing It and When a Pump Could Help
Struggling with low water pressure? Discover the common causes, learn when a booster pump is the right fix, and connect with vetted Kandua plumbers.

A weak shower in the morning. A washing machine that takes forever to fill. Low water pressure wears you down.
A few simple checks can often narrow down the cause and a vetted plumber can confirm the rest.
Is It the Whole House or Just One Tap?
If It Is Just One Tap or Shower
The problem is often in that tap or shower itself. It could be:
- A clogged aerator or shower head. The aerator is the small mesh nozzle at the tip of your tap. Limescale and grit can block it over time.
- A worn washer inside the tap. Small rubber washers wear out with use and restrict water flow.
- A half closed valve. Many basins and toilets have a small tap on the pipe underneath. If it is partly closed, less water gets through.
If It Is Only the Hot Water
If cold taps are fine but hot taps are weak, the cause could be linked to your geyser or hot water pipework. Leave anything on the geyser or pipework to a qualified plumber.
Find geyser repair specialists in your area.
If It Is Every Tap in the House
The cause is usually further back in your water supply. It could be:
- Low pressure from the municipality. Some areas get a weaker supply, especially at busy times of day.
- A main water tap that is not fully open. This is called the stopcock. It controls all the water coming into your property and is usually near your water meter.
- A hidden leak underground or inside a wall.
- Old pipes. Older steel pipes can rust and narrow on the inside, a bit like a clogged straw.
What Is a Booster Pump and Could It Help?
A booster pump is a small electric device that increases the water pressure in your pipes.
It could help if:
- Your municipal pressure is low most of the time and your pipes are in good condition
- Upstairs bathrooms struggle while downstairs taps are fine
- You have a Jojo tank for backup and need to get that water into the house
When a Pump Is Not the Answer
If the real cause is a leak, a blocked pipe or a faulty valve, a pump could hide the problem instead of solving it. Also keep in mind:
- A pump cannot create water during an outage unless it draws from a tank.
- A pump runs on electricity, so it will not work during load shedding without backup power.
Who Should Install a Booster Pump?
This is not a DIY project. Connecting a pump or tank to your home’s water supply is regulated plumbing work for a qualified plumber. It should include backflow prevention, which stops water in your system flowing back into the municipal supply. The electrical connection needs a registered electrician.
Find a vetted plumber for your pump installation.
Every plumber and electrician on Kandua is background checked and has their qualifications verified, so you know who is coming through your gate.
“Ask who will do the electrical connection before any work starts. Water and electricity need a qualified hand.” Frank, vetted plumber from Alberton.
What Should a Pump Quote Include?
Before you say yes, check that the quote covers:
- What the plumber found and why a pump is needed
- The pump brand, model and size
- Extra parts such as a pressure tank, which helps the pump run smoothly instead of switching on and off all the time
- Fittings, valves and pipework
- Who will do the electrical connection
- The call out fee and labour
- The warranty on the pump and the workmanship
If anything is unclear, ask before you approve. On Kandua you can see your quote, approve it and pay securely in one place. Our Water Pump Repair Cost guide puts a new booster pump installation at about R4,000 to R9,000, including the pump and labour.
Find a Vetted Plumber on Kandua.com
Tell us what is happening at home and we will connect you with a vetted plumber near you to find the cause and fix it properly.
Find a vetted plumber for your pump on Kandua.com
Frequently Asked Questions
Why has my water pressure suddenly dropped?
It could be a supply problem in your area, a leaking pipe or a fault with your pump. A vetted plumber can help you confirm which.
Why does my pump keep switching on and off?
This is known as short cycling. It could be a leak, a pressure tank problem or a faulty pressure switch, the part that tells the pump when to start and stop.
Do I need a COC for a booster pump?
Ask your plumber and electrician whether a COC is needed for the work and to include it in the quote.
Do I need a pump if I have a Jojo tank?
Often, yes. Unless the tank is raised high enough for gravity to do the work, a pump is usually needed to get the water into your house. A plumber can confirm the right setup.
Can I install a booster pump myself?
It is not advised. Connecting to your house supply is regulated plumbing work and the electrical side needs a registered electrician.

Latest articles, advice and more
.webp)
Hosting This December? Here are tips and hacks to help you get your home prepped for the holidays.
If you are hosting at your home this December, the smartest move you can make is booking your home repairs sooner. Book a vetted professional on Kandua.com now, while there’s still time to have the work done properly.
.webp)
Beyond the Unboxing: A Detailed Guide to Correct Washing Machine Plumbing & Setup
New washing machine in South Africa? Learn essential plumbing and setup tips to prevent leaks, ensure efficient operation, and extend your appliance’s lifespan - expert advice before your first load.
.webp)
New Washing Machine? Don't Plug It In Yet! Essential Installation Tips for SA Homes
Installing a new washing machine? Learn the essential setup steps South African homeowners often overlook to prevent leaks, noise, and damage—and ensure efficient, long-lasting performance from day one.

Electric Fencing Repair Costs in South Africa
Electric fencing repair costs in South Africa depend on what has failed, when you call for help and which parts are needed. Minor electric fence repairs usually cost R500 to R1,500. Larger faults can cost R2,000 to R5,000 or more.
How to Install a Horizontal Geyser | Step-by-Step Pro Guide
Want to install a geyser like a pro? This step-by-step tutorial shows you exactly how to do a horizontal Ariston Axios geyser installation, straight from the BluLever plumbing workshop. 🎥 Hosted by MK, BluLever’s technical facilitator, and supported by a qualified electrician, Life and a BluLever graduate artisan, Zinhle. This is your ultimate guide to a SANS 10254-compliant installation — from preparing the wall, to plumbing, electrical wiring, and pro troubleshooting tips.
How to Maintain a Geyser | Step-by-Step Pro Guide
Want to maintain a geyser like a pro? This step-by-step tutorial shows you exactly how to do the three core geyser maintenance checks on an Ariston Axios geyser installation, straight from the BluLever plumbing workshop. 🎥 Hosted by MK, BluLever’s technical facilitator, and supported by a qualified electrician, Life. This is your ultimate guide to geyser maintenance — from diagnosing the problem to checking the heat regulation of the geyser, to pressure regulation and then finally corrosion protection.
Not just another newsletter. It's an advantage

.webp)
.webp)
.webp)

.webp)

.webp)
%201.avif)
