I need a three phase power outlet that used to connect to my old stove to be converted into a single phase supply for a new stove.

It's a small bathroom in the basement and I need an expert in extractor fans. Thanks

Hi, ideally today or tomorrow morning I need an electrician to come and mark in my kitchen where the isolater needs to be. My current electrician never turned up and I habe workers tomorrow who need that info. Apart from this I need to get this done : Electrical tasks: Kitchen: - Take wires to new isolator point by the stove/oven. (determine if that is legal that distance). - Shift plug point closer to main box on back wall. - Install floating plugs for LED lights and Fridge. - Make all plug boxes ready for covers to be put in at the end. (covers to go over stone). - Keep wiring for plug in bathroom for the washing machine (currently it leads to old washing machine by the window, it a black cable, this needs to go through the wall into the bathroom). - Clean up and remove ALL unneeded cables (esp those running to outside for hanginf lights, left of the kitchen. Bathroom: - Install new plug point for washing machine under geyser. 2nd Bedroom: Nothing Main Bedroom: - Assess installing a plug to desk position (possibly run cable on the outside of the building). - install plug box for new plug position on the right hand side of the room. Lounge: - No changes Outside: - Test pool pump electrics, determine cause for pump issue. - Test outside plug (it leads from the left plug point in the lounge, to an outside plug, the cover is missing. (this can be used for new lighting on the deck at some point). - Test outside lights (lights by the braai area, source is a plug point in lounge by the wifi).

Replacing a pendant light fixture with another pendant light fixture (similar sized so no additional work needed for ceiling) will also need to shorten the pendant wires to hang at the right height.

We have purchased a 3kva multiplies and 5kwh inverter for installation in our apartment. We need you to bring sundries cables etc. we have all the other hardware, I will send equipment list before the install.

Move light from wall to ceiling (no grinding off wall) cable to be exposed

There currently isn't heat in geyser. The thermostat and element was replaced but the person mentioned that the relay for the geyser is very old and need to be replaced. So the work is probably to replace the relay in the db board (but you would have to inspect to tell if this is the case.)

I would like to install an extractor fan and another extractor fan with built in heater lamps in my two bathrooms above the showers/toilets adn would like them to have separate switches so that they can turn on with the bathroom light but also be switched off if not using the shower etc. I can purchase the items and supply them for fitment or if the supplied and fitted price is good then am open to taking all through you.

The damage to the kitchen light was caused by a plumbing/water leak from the residential unit above mine. The leak has been repaired but light not working. The address would be: 19 Frederick Road, 6 Stone Crest Kengies Ext 20 Broadacres

strange system, of course there is more than just switches: 1) couple of more outlets (EURO and SA and USB), 2)installing some light fixtures, 3)installing some LED strips and 4)checking the overall elactricity and 5)a COC.

I need a three phase power outlet that used to connect to my old stove to be converted into a single phase supply for a new stove.

It's a small bathroom in the basement and I need an expert in extractor fans. Thanks

Hi, ideally today or tomorrow morning I need an electrician to come and mark in my kitchen where the isolater needs to be. My current electrician never turned up and I habe workers tomorrow who need that info. Apart from this I need to get this done : Electrical tasks: Kitchen: - Take wires to new isolator point by the stove/oven. (determine if that is legal that distance). - Shift plug point closer to main box on back wall. - Install floating plugs for LED lights and Fridge. - Make all plug boxes ready for covers to be put in at the end. (covers to go over stone). - Keep wiring for plug in bathroom for the washing machine (currently it leads to old washing machine by the window, it a black cable, this needs to go through the wall into the bathroom). - Clean up and remove ALL unneeded cables (esp those running to outside for hanginf lights, left of the kitchen. Bathroom: - Install new plug point for washing machine under geyser. 2nd Bedroom: Nothing Main Bedroom: - Assess installing a plug to desk position (possibly run cable on the outside of the building). - install plug box for new plug position on the right hand side of the room. Lounge: - No changes Outside: - Test pool pump electrics, determine cause for pump issue. - Test outside plug (it leads from the left plug point in the lounge, to an outside plug, the cover is missing. (this can be used for new lighting on the deck at some point). - Test outside lights (lights by the braai area, source is a plug point in lounge by the wifi).